
Rockstar Sealing
GREEN STAR SEALER
Rockstar GREEN STAR SEALER is a water-based penetrating sealer formulated for use on a wide variety of mineral-based floor finishes including natural and man-made stone, tiles, concrete, and terracotta. It’s applied as a final coat to the floor surface to protect against the ingress of oil and waterborne staining substances.
Description
Rockstar GREEN STAR SEALER is a water-based penetrating sealer formulated for use on a wide variety of natural stones such as Marble, Limestone and Terrazzo.
USES
GREEN STAR SEALER will protect against the ingress of oil and water borne staining substances. Excellent for use in food environments and where solvent based sealers cannot be used.
BENEFITS
• Environmentally friendly with low VOC content
• Does not change the appearance of the treated surface
• Durable and highly water and stain resistant
• Does not inhibit the water-vapour permeability
• Ready to apply, no dilution required
• Rapid curing
• UV Stable
Technical Data Sheets
Please access the product information sheet and Material Safety Data Sheet (MSDS) below:
PROPERTIES
Appearance and colour………………………………….Amber Liquid
PH………………………………………………….……………7-8
Specific Gravity (Water = 1) …………………………..1 g/ml
Boiling Point ………………………………………………..100oC
Solubility in Water ………………………………………..Miscible
Flash Point ………………………………………………….Non-flammable
VOC Content ………………………………………………38 gm/Lt
APPLICATION INSTRUCTIONS
-
Always apply first to an inconspicuous area or scrap piece of stone to ensure the suitability of this product for your floor finish.
-
Ensure the surface to be sealed is clean, dry and free of any oils and other surface contaminants.
-
Apply GREEN STAR SEALER undiluted using a lambswool applicator or low pressure hand sprayer.
-
Ensure that the surface is evenly coated without leaving wet pools of product on the surface. Apply a second coat as soon as the first coat has dried (1-2hr).
-
The product will cure in 5-10 hours depending on atmospheric conditions.COVERAGE
COVERAGE
Coverage is dependent on the permeability of the surface and is in the range of 6-10 Mt2 per litre.
PRECAUTIONS
- Do not allow pools of liquid GREEN STAR SEALER to dry on the surface as a resin will develop on the surface that is difficult to remove.
- Follow good industrial hygiene practices when using this product. Avoid contact with skin and eyes by wearing suitable protective gloves and eyewear.
Greenstar Sealer is below the VOC Content limits of chosen category specified by Green Star Design, Green Building Council of Australia.
CLEANING
Clean all equipment in water.
PACKAGING
GREEN STAR SEALER is available in 1, 5 and 20 litre packs.
STORAGE
Keep container tightly closed when not in use. Store in a cool, dry place out of reach of children.
DISCLAIMER
The advice and information contained herein is based on our best knowledge of the product. We believe the information to be accurate and reliable as at the date supplied, but no representation, guarantee or warranty, expressed or implied, is made to the accuracy, reliability, or completeness of the advice and information. We urge persons receiving this advice and information to make their own determination as to the advice and information’s suitability and completeness for their own particular situation. When in doubt it is always prudent to perform a trial on a scrap section of material, or inconspicuous section of the job to ascertain the products suitability.
Additional information
Size |
1L, 5L, 20L |
---|
Technical Data Sheets
Please access the product information sheet and Material Safety Data Sheet (MSDS) below:
Green Star Sealer Product Fact Sheet
Green Star Sealer Material Safety Data Sheet